Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Need Some Help With Aero Porting For My 9515s Going In My Ford Ranger
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Th3pWn3r" data-source="post: 8310121" data-attributes="member: 576149"><p>Hello, I'm planning on building a box using 4'' aero ports(I already have them). The problem is that when I enter my dimensions into the calculator I'm using I get negative port area. The box is for my DD 9515s and is going in my Ford Ranger, I was shooting for 5 CU FT. per sub after displacement with a tune of 35hz. The wedge design I had in mind was basically the max dimensions I could fit of 50'' wide, bottom depth being 16'', top depth being 11''(this just clears the seats) and a height of 36''. I know I won't be seeing out my windows in the rear but this is what it takes to get the air space I'm shooting for without doing a blow-through box. If anyone could help I'd appreciate it a lot, thanks in advance.</p></blockquote><p></p>
[QUOTE="Th3pWn3r, post: 8310121, member: 576149"] Hello, I'm planning on building a box using 4'' aero ports(I already have them). The problem is that when I enter my dimensions into the calculator I'm using I get negative port area. The box is for my DD 9515s and is going in my Ford Ranger, I was shooting for 5 CU FT. per sub after displacement with a tune of 35hz. The wedge design I had in mind was basically the max dimensions I could fit of 50'' wide, bottom depth being 16'', top depth being 11''(this just clears the seats) and a height of 36''. I know I won't be seeing out my windows in the rear but this is what it takes to get the air space I'm shooting for without doing a blow-through box. If anyone could help I'd appreciate it a lot, thanks in advance. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Need Some Help With Aero Porting For My 9515s Going In My Ford Ranger
Top
Menu
Home
Refresh