Reply to thread

Message

<blockquote data-quote="UNCFMM" data-source="post: 980188" data-attributes="member: 561492">Some of you might remember me, I asked awhile back for some opinions on what subs/amp/box and etc. I should get but now I&#039;ve gotten dual 12&quot; Infinity Reference 1230s and a R/T dual 12&quot; enclosure.&nbsp; I&#039;ve pretty much narrowed it down to the <a href="http://www.cardomain.com/item/MTX564" target="_blank">MTX Thunder564</a> from CarDomain.com.&nbsp; (If anyone thinks that&#039;s a bad setup just tell me so, I wanted to get a 2Ch. amp but if I even get a good name brand that gives out 200W it&#039;s a ton of money... so I figured a 4Ch. amp would be my best option)The specs for the subs are:- Infinity Reference 1230w- 90dB- 4ohms- 300W RMS; 1200W PeakI saw the amp wires on CarDomain.com, called &quot;StreetWires&quot; but I don&#039;t know what wires I&#039;m supposed to get (8 Gauge, 4 Gauge)?I&#039;m putting this in my &#039;96 Jeep Grand Cherokee which comes standard with an alarm but I&#039;ve had some drunk friends pushing my car around a little bit when it was armed so I&#039;m not sure what will actually make it go off.&nbsp; Point being that I don&#039;t know if I should go ahead and spend more money to get another alarm installed or whether I should just trust my factory one.So can you all just give me a little help here seeing as how most of you are experts at this stuff?- Is the MTX Thunder564, and two Infinity Reference 1230s in a R/T enclosure a good setup?- What type of wires will I need, 4 gauge or 8 gauge and is Streetwires a good brand to go with?- Other then those wires, what else do I need to install this system in a &#039;96 Jeep GC?- Should my car be in pretty good condition security-wise with just the factory alarm?- I was going to get the stuff installed at Circuit City but is there a better place out there to get it done or is Circuit City good enough?Thanks for any help in advance!</blockquote>

[QUOTE="UNCFMM, post: 980188, member: 561492"] Some of you might remember me, I asked awhile back for some opinions on what subs/amp/box and etc. I should get but now I've gotten dual 12" Infinity Reference 1230s and a R/T dual 12" enclosure. I've pretty much narrowed it down to the [URL="http://www.cardomain.com/item/MTX564"]MTX Thunder564[/URL] from CarDomain.com. (If anyone thinks that's a bad setup just tell me so, I wanted to get a 2Ch. amp but if I even get a good name brand that gives out 200W it's a ton of money... so I figured a 4Ch. amp would be my best option) The specs for the subs are: - Infinity Reference 1230w - 90dB - 4ohms - 300W RMS; 1200W Peak I saw the amp wires on CarDomain.com, called "StreetWires" but I don't know what wires I'm supposed to get (8 Gauge, 4 Gauge)? I'm putting this in my '96 Jeep Grand Cherokee which comes standard with an alarm but I've had some drunk friends pushing my car around a little bit when it was armed so I'm not sure what will actually make it go off. Point being that I don't know if I should go ahead and spend more money to get another alarm installed or whether I should just trust my factory one. So can you all just give me a little help here seeing as how most of you are experts at this stuff? - Is the MTX Thunder564, and two Infinity Reference 1230s in a R/T enclosure a good setup? - What type of wires will I need, 4 gauge or 8 gauge and is Streetwires a good brand to go with? - Other then those wires, what else do I need to install this system in a '96 Jeep GC? - Should my car be in pretty good condition security-wise with just the factory alarm? - I was going to get the stuff installed at Circuit City but is there a better place out there to get it done or is Circuit City good enough? Thanks for any help in advance! [/QUOTE]

Verification