Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Need help with sub and amp..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="mikeyfid" data-source="post: 8248702" data-attributes="member: 660494"><p>Hello everyone, I have some sort of problem with my setup and need a little advice. Gone through 2 kicker compr subs. 800rms. 1ohm stable. Wired to 1 ohm. Paired with a pioneer gm-d8601 mono 800rms at 1 ohm. Will have pics for settings on amp. HU settings are sub +1 db..lpf is 120hz.. slope 2.. loudness off.. First sub fried within a day. Second one lasted a couple days. Running 1 sub at a time. Ported metra box from bestbuy. Done a handful of systems before and never had this problem. Big 3 also done with 0gauge and 4gauge power to the amp with 4gauge ground. 10gauge speaker wire. Amp has never went into protect mode. Just suddenly I hear no bass and open the trunk with smoke coming from the port. Just second guessing myself on the install right now. HU goes up to 50 i nevrr go past 35. Normally around 27 28. Its a sony cdx gt575up. Any advice would help. The coil is uncoiled after this happens and I can't push the sub in. Its stiff.</p></blockquote><p></p>
[QUOTE="mikeyfid, post: 8248702, member: 660494"] Hello everyone, I have some sort of problem with my setup and need a little advice. Gone through 2 kicker compr subs. 800rms. 1ohm stable. Wired to 1 ohm. Paired with a pioneer gm-d8601 mono 800rms at 1 ohm. Will have pics for settings on amp. HU settings are sub +1 db..lpf is 120hz.. slope 2.. loudness off.. First sub fried within a day. Second one lasted a couple days. Running 1 sub at a time. Ported metra box from bestbuy. Done a handful of systems before and never had this problem. Big 3 also done with 0gauge and 4gauge power to the amp with 4gauge ground. 10gauge speaker wire. Amp has never went into protect mode. Just suddenly I hear no bass and open the trunk with smoke coming from the port. Just second guessing myself on the install right now. HU goes up to 50 i nevrr go past 35. Normally around 27 28. Its a sony cdx gt575up. Any advice would help. The coil is uncoiled after this happens and I can't push the sub in. Its stiff. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Need help with sub and amp..
Top
Menu
What's new
Forum list