Reply to thread

Message

<blockquote data-quote="beav626" data-source="post: 6797592" data-attributes="member: 606617">in my 03 Escalade using my Eclipse AVN6600 Everything was good until my See down button stopped responding. (was using SWI-ECL)So I figured it was time to upgrade to the ECL2 unit.I can get ti to work at all.I wire it up just like Im supposed to (identical to the ECL1)When I begin to program I get odd results.Version # accepts.When I start to program buttons&nbsp; I do them in order Vol up then Vol down, Mode, Seek up and Seek downSometimes when I get to Vol down My onstar starts and shuts my head unit off. I have to start over. ( i dont even use Onstar)other times I get half way through the programming and the LED starts to flash 3 times , then 3 times again, then steady-and sends my Volume to the max.I called PAC and they said I have a bad unit.Has anyone seen this or can help me</blockquote>

[QUOTE="beav626, post: 6797592, member: 606617"] in my 03 Escalade using my Eclipse AVN6600 Everything was good until my See down button stopped responding. (was using SWI-ECL) So I figured it was time to upgrade to the ECL2 unit. I can get ti to work at all. I wire it up just like Im supposed to (identical to the ECL1) When I begin to program I get odd results. Version # accepts. When I start to program buttons I do them in order Vol up then Vol down, Mode, Seek up and Seek down Sometimes when I get to Vol down My onstar starts and shuts my head unit off. I have to start over. ( i dont even use Onstar) other times I get half way through the programming and the LED starts to flash 3 times , then 3 times again, then steady-and sends my Volume to the max. I called PAC and they said I have a bad unit. Has anyone seen this or can help me [/QUOTE]

Verification