Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
need help modifying my box
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="silverlude56" data-source="post: 908603" data-attributes="member: 557851"><p>well i built a box and it was too big. (ITS PORTED and thats whats complicating things)</p><p></p><p>what im trying to do is shorten it down enough that i can get it out of the trunk without taking it apart and therefore once that is accomplished it can be glued airtight unlike it is now.</p><p></p><p>i plan to leave the height 13.5" (since the sub is a 12") and width 25"</p><p></p><p>therefore the port hole will be the same size and i will cut down on box size reducing the depth. i need to kno if its possible to change the length or design of the boards on the inside of the port (the boards that make up the L) to match up with the original tuning frequency?</p></blockquote><p></p>
[QUOTE="silverlude56, post: 908603, member: 557851"] well i built a box and it was too big. (ITS PORTED and thats whats complicating things) what im trying to do is shorten it down enough that i can get it out of the trunk without taking it apart and therefore once that is accomplished it can be glued airtight unlike it is now. i plan to leave the height 13.5" (since the sub is a 12") and width 25" therefore the port hole will be the same size and i will cut down on box size reducing the depth. i need to kno if its possible to change the length or design of the boards on the inside of the port (the boards that make up the L) to match up with the original tuning frequency? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
need help modifying my box
Top
Menu
Home
Refresh