Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Need Box Help!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Inferno13" data-source="post: 61542" data-attributes="member: 542918"><p>alright i dont remember it being this hard. im trying to figure out what angle i want the box to be cut at. (the angle of the triangle part of the trapezoid). it's very dificult to figure out how to make this 1.25 cft. i was wondering if you could help. i think that id want the angle to be about 35 to 40 degrees and then figure it out from there. but now im starting to wonder if i should make the enclosure just a rectangle. what shape would give me the best wave response? i think i will just go with the rectangle. well back to the drawing board.</p></blockquote><p></p>
[QUOTE="Inferno13, post: 61542, member: 542918"] alright i dont remember it being this hard. im trying to figure out what angle i want the box to be cut at. (the angle of the triangle part of the trapezoid). it's very dificult to figure out how to make this 1.25 cft. i was wondering if you could help. i think that id want the angle to be about 35 to 40 degrees and then figure it out from there. but now im starting to wonder if i should make the enclosure just a rectangle. what shape would give me the best wave response? i think i will just go with the rectangle. well back to the drawing board. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Need Box Help!
Top
Menu
Home
Refresh