Reply to thread

Message

<blockquote data-quote="req" data-source="post: 2490629" data-attributes="member: 555713">ive never used these before, but they would prolly work well in your application.<a href="http://www.partsexpress.com/pe/showdetl.cfm?&amp;amp;Partnumber=264-837" target="_blank">http://www.partsexpress.com/pe/showdetl.cfm?&amp;amp;Partnumber=264-837</a>get a small 4 channel amplifier, and bridge channel 3+4 with the subs wired from 8ohm down to 4 ohm and run channel 1+2 to your front components. should do exac tally what you are looking for and be a simple drop in installation.//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gifps, infinite baffle is a enclosure alignment like sealed or ported (aka, single reflex), or bandpass that only takes twice the VAS of the speaker as a requirement. the VAS of a speaker is (in liters) how much volume the recommended sealed enclosure would be (if i recall correctly that is). and you just basically need to seal the rear of the driver from the front of the driver. no &quot;enclosure&quot; is nessicary as long as&nbsp; the front waves can not interact with the rear waves.</blockquote>

[QUOTE="req, post: 2490629, member: 555713"] ive never used these before, but they would prolly work well in your application. [URL="http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=264-837"]http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=264-837[/URL] get a small 4 channel amplifier, and bridge channel 3+4 with the subs wired from 8ohm down to 4 ohm and run channel 1+2 to your front components. should do exac tally what you are looking for and be a simple drop in installation. [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] ps, infinite baffle is a enclosure alignment like sealed or ported (aka, single reflex), or bandpass that only takes twice the VAS of the speaker as a requirement. the VAS of a speaker is (in liters) how much volume the recommended sealed enclosure would be (if i recall correctly that is). and you just basically need to seal the rear of the driver from the front of the driver. no "enclosure" is nessicary as long as the front waves can not interact with the rear waves. [/QUOTE]

Verification