Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
Need Advice and Help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="BEAVER.989" data-source="post: 4608029" data-attributes="member: 567334"><p>Here's where I'd start...</p><p></p><p>Reverse the polarity of both of the tweeters and while you're at it, set the tweeters to the lowest attenuation possible at the x-over. Boost the mids at the x-over as well, never heard of this myself, but according the woofersetc. page on your drivers this is possible.</p><p></p><p>I'd then lower the gains a bit and re-run the Imprint kit. After that I'd crank the gains back up until I reached the level of performance I was looking for(without distortion).</p><p></p><p>If this sounds worse(I don't think it will), go back to your original settings.</p></blockquote><p></p>
[QUOTE="BEAVER.989, post: 4608029, member: 567334"] Here's where I'd start... Reverse the polarity of both of the tweeters and while you're at it, set the tweeters to the lowest attenuation possible at the x-over. Boost the mids at the x-over as well, never heard of this myself, but according the woofersetc. page on your drivers this is possible. I'd then lower the gains a bit and re-run the Imprint kit. After that I'd crank the gains back up until I reached the level of performance I was looking for(without distortion). If this sounds worse(I don't think it will), go back to your original settings. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
Need Advice and Help
Top
Menu
What's new
Forum list
