Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
my amp keeps going into protect
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="supa93poo" data-source="post: 372304" data-attributes="member: 552417"><p>my amp sucks.Its hooked up to a 10 inch boston acoustic. my amp by the way is a sony 760x2 it plays fine at low volume with low bass.</p><p></p><p>i've had 3 amps hooked up to it so far and they all went into protect mode. i wired it all right. i checked it 9 thousand times.</p><p></p><p>i ran it in bridged mode on all the amps and it went into protect mode on every one. i then ran it on 1 of the two channels and every one still did it. i was wondering if it could be the wire size?</p><p></p><p>i am running 8 guage wire for both the ground and the battery wire. it is running 400 watts peak when it is bridged and somwhere around 250-300 RMS. i also have house entertainment rca's hooked up but i dont know if there is a difference. i think the other rca's that i have were a little thicker. would that matter at all? i also have the power wire fuse probably about 8 inches from the amp. i dont know if that matters at all. PLEASE HELP ME IT IS DRIVING ME CRAZY thanks</p></blockquote><p></p>
[QUOTE="supa93poo, post: 372304, member: 552417"] my amp sucks.Its hooked up to a 10 inch boston acoustic. my amp by the way is a sony 760x2 it plays fine at low volume with low bass. i've had 3 amps hooked up to it so far and they all went into protect mode. i wired it all right. i checked it 9 thousand times. i ran it in bridged mode on all the amps and it went into protect mode on every one. i then ran it on 1 of the two channels and every one still did it. i was wondering if it could be the wire size? i am running 8 guage wire for both the ground and the battery wire. it is running 400 watts peak when it is bridged and somwhere around 250-300 RMS. i also have house entertainment rca's hooked up but i dont know if there is a difference. i think the other rca's that i have were a little thicker. would that matter at all? i also have the power wire fuse probably about 8 inches from the amp. i dont know if that matters at all. PLEASE HELP ME IT IS DRIVING ME CRAZY thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
my amp keeps going into protect
Top
Menu
What's new
Forum list
