Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Subwoofers
MRP-M500 in protect?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="TheHammer12" data-source="post: 6441922" data-attributes="member: 605454"><p>Ok I'm having a problem with my Alpine MRP-M500. I think it is going into protect. When I play a bass heavy song at like 20ish on the HU in plays fine, but if I go to like 25 (HU goes to 35) on a real bass heavy song the sub stops playing so I think the amp is going into protect. The gain is at max (I know prob a little too high, but I've run it like this for 3+ months without any problems). Bass boost is at zero. LPF is at 100hz on amp, 80hz on HU. I think the sub might have a dead coil or something which is causing my impedance to do something weird and put it into protect? So idk, any ideas?</p><p></p><p>Oh crud, meant to post this in the Amplifier section, my bad, if a mod could move it it would be most appreciated.</p></blockquote><p></p>
[QUOTE="TheHammer12, post: 6441922, member: 605454"] Ok I'm having a problem with my Alpine MRP-M500. I think it is going into protect. When I play a bass heavy song at like 20ish on the HU in plays fine, but if I go to like 25 (HU goes to 35) on a real bass heavy song the sub stops playing so I think the amp is going into protect. The gain is at max (I know prob a little too high, but I've run it like this for 3+ months without any problems). Bass boost is at zero. LPF is at 100hz on amp, 80hz on HU. I think the sub might have a dead coil or something which is causing my impedance to do something weird and put it into protect? So idk, any ideas? Oh crud, meant to post this in the Amplifier section, my bad, if a mod could move it it would be most appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Subwoofers
MRP-M500 in protect?
Top
Menu
Home
Refresh