Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
More gain setting questions....
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Phreaker" data-source="post: 2037873" data-attributes="member: 567899"><p>The amps specs at 12 volts are as follows:</p><p></p><p>500w x 1 channel @ 4 ohms</p><p></p><p>700w RMS x 1 channel @ 2 ohms</p><p></p><p>Amps specs 1ith 14.4 volts:</p><p></p><p>1000w RMS x 1 channel @ 2 ohms</p><p></p><p>I'd say it'll be about 900w RMS.So using the DMM set to AC voltage on the amps speaker terminals and the car on and running and HU volume set to max volume before clipping start turning the gain up until the DMM reads about 40v AC on a 40-50Hz test tone tht was recorded at 0db's which can be found at ROE in the downloads section.</p></blockquote><p></p>
[QUOTE="Phreaker, post: 2037873, member: 567899"] The amps specs at 12 volts are as follows: 500w x 1 channel @ 4 ohms 700w RMS x 1 channel @ 2 ohms Amps specs 1ith 14.4 volts: 1000w RMS x 1 channel @ 2 ohms I'd say it'll be about 900w RMS.So using the DMM set to AC voltage on the amps speaker terminals and the car on and running and HU volume set to max volume before clipping start turning the gain up until the DMM reads about 40v AC on a 40-50Hz test tone tht was recorded at 0db's which can be found at ROE in the downloads section. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
More gain setting questions....
Top
Menu
What's new
Forum list
