Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
Memphis amp question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="alexkerhead" data-source="post: 1014412" data-attributes="member: 549500"><p>OK, so, I got a 500watt rms class -D Memphis amplifier.</p><p></p><p>I am getting two 10 inch m-class, dual voice coils each.</p><p></p><p>I need to know, is there going to be too much strain on the amp with two dual voice coil subs?</p><p></p><p>I know I should have gone with svc, but too late.</p><p></p><p>Another question.</p><p></p><p>I dnt want to wire two terminal sets up for each speaker on the box I built, so is it ok if I wire the two voice coils together in a sequence, like pos, neg, pos, neg ?</p><p></p><p>Or do I need to just run them together acting as one voice coil?</p><p></p><p>I appreciate the help.</p><p></p><p>I always wanted a high quality memphis system, I finally am getting the chance to own one, so I dont want to fry anything.</p></blockquote><p></p>
[QUOTE="alexkerhead, post: 1014412, member: 549500"] OK, so, I got a 500watt rms class -D Memphis amplifier. I am getting two 10 inch m-class, dual voice coils each. I need to know, is there going to be too much strain on the amp with two dual voice coil subs? I know I should have gone with svc, but too late. Another question. I dnt want to wire two terminal sets up for each speaker on the box I built, so is it ok if I wire the two voice coils together in a sequence, like pos, neg, pos, neg ? Or do I need to just run them together acting as one voice coil? I appreciate the help. I always wanted a high quality memphis system, I finally am getting the chance to own one, so I dont want to fry anything. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
Memphis amp question
Top
Menu
Home
Refresh