Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
MDF rings
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Rawr-DQ" data-source="post: 953847" data-attributes="member: 558585"><p>I've cut holes with a jigsaw all the time...'</p><p></p><p>Just put a dot where you want the center to be, measure a few times around the circle (the radius) and draw some lines there. Take a scrap piece of wood, nail it to the center, make a small hole in the wood which will be at radius of the circle, use a pencil and move it in a circle....or tie a string to the length of the radius and do the same thing.</p><p></p><p>Then follow the lines with the jigsaw... to start the cuts, I take a drill bit and make a hole large enough to fit the jigsaw blade in it.</p><p></p><p>SHA BAM</p></blockquote><p></p>
[QUOTE="Rawr-DQ, post: 953847, member: 558585"] I've cut holes with a jigsaw all the time...' Just put a dot where you want the center to be, measure a few times around the circle (the radius) and draw some lines there. Take a scrap piece of wood, nail it to the center, make a small hole in the wood which will be at radius of the circle, use a pencil and move it in a circle....or tie a string to the length of the radius and do the same thing. Then follow the lines with the jigsaw... to start the cuts, I take a drill bit and make a hole large enough to fit the jigsaw blade in it. SHA BAM [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
MDF rings
Top
Menu
What's new
Forum list
