Reply to thread

Message

<blockquote data-quote="Hcw" data-source="post: 7650336" data-attributes="member: 637045">I am having difficulty understanding the instructions&nbsp; on&nbsp; installing&nbsp; this amp in a 3 way configuration.First is that my&nbsp; Alpine head unit has only one set of rca outputs.&nbsp; In the three way&nbsp; configuration&nbsp; would I still have to&nbsp; use&nbsp; 2 “Y”&nbsp; splitters&nbsp; to connect&nbsp; to the amp?&nbsp; A second 2 ch amp will be attached&nbsp; to this amps&nbsp; outputs to&nbsp; feed a separate set of&nbsp; front speakers .Second:&nbsp; Am I correct in assuming that it will be a 4 ohm load&nbsp; and require a single voice coil&nbsp; 4 ohm subwoofer&nbsp; if bridging&nbsp; channel 3 and 4 .( just want to confirm it isn’t a 2 0hm load)Page 5 has a diagram.<a href="http://www.maxxsonics.net/manuals/mbquart/pdfs/MB%20Quart%202010%20Q%20Amplifier%20Manual.pdf" target="_blank">http://www.maxxsonics.net/manuals/mbquart/pdfs/MB%20Quart%202010%20Q%20Amplifier%20Manual.pdf</a></blockquote>

[QUOTE="Hcw, post: 7650336, member: 637045"] I am having difficulty understanding the instructions on installing this amp in a 3 way configuration. First is that my Alpine head unit has only one set of rca outputs. In the three way configuration would I still have to use 2 “Y” splitters to connect to the amp? A second 2 ch amp will be attached to this amps outputs to feed a separate set of front speakers . Second: Am I correct in assuming that it will be a 4 ohm load and require a single voice coil 4 ohm subwoofer if bridging channel 3 and 4 .( just want to confirm it isn’t a 2 0hm load) Page 5 has a diagram. [URL="http://www.maxxsonics.net/manuals/mbquart/pdfs/MB%20Quart%202010%20Q%20Amplifier%20Manual.pdf"]http://www.maxxsonics.net/manuals/mbquart/pdfs/MB%20Quart%202010%20Q%20Amplifier%20Manual.pdf[/URL] [/QUOTE]

Verification