Reply to thread

Message: <blockquote data-quote="jjones5000" data-source="post: 2159983" data-attributes="member: 570686">Hi, i have a ma audio hk-800d mono amp. I recently purchased an alpine cda-9813. Before i had a pioneer deh-p4400, so i went from 2v pre-outs to 4v pre-outs. On my amp it was an input sensitivity switch (wish my girlfriend had one of these) anyway my two options are .2Mv-2v and 2v-8v. When i swith to the higher of the two output is drastically reduced, as expected. So much so that when volume as at 25 out of 35 max, and gain all the way up and bas boost all the way up, there is almost no output at all. I don't want to run it out of spec or anything, but i also want good bass. Not a fricken ton or anything, just more then i get when on 4v setting.ThanksAlso, in case you're wondering x-over on deck is set to 200mhz l/p 18db/oct. And x-over on amp is set similar.</blockquote>

Top