Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Looking for some help with port calculations.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="macisme" data-source="post: 7313409" data-attributes="member: 594818"><p>Lol yea you are right. We did plan it out, however once we got into it a little more some things wouldn't fit and we had to switch the design. Too much airspace can be fixed by adding my 2nd ply inside the box instead of the outside as well as just more/thicker bracing I'm sure. I'm sorry I should have made it known that I was doubling up on the whole box to keep it from flexing when it's all done. I have all the pieces cut, except for the doubling up pieces. I've only built two other boxes so I'm just learning as I go man, so any advice you can give me is greatly appreciated. I am just looking for suggestions on port sizes etc. after I get my bracing in and account for sub displacement I will probably get more into the port design, since I'll have a better idea of the air space I'll be left with. I'm not very good as designing things, only changing them on the fly and making things more difficult lol.</p><p></p><p>I am looking to make it around 36-38 hertz, do you think that's a decent tuning for these subs? I am wanting to try and pull hair tricks, even if they aren't much of one at all...</p></blockquote><p></p>
[QUOTE="macisme, post: 7313409, member: 594818"] Lol yea you are right. We did plan it out, however once we got into it a little more some things wouldn't fit and we had to switch the design. Too much airspace can be fixed by adding my 2nd ply inside the box instead of the outside as well as just more/thicker bracing I'm sure. I'm sorry I should have made it known that I was doubling up on the whole box to keep it from flexing when it's all done. I have all the pieces cut, except for the doubling up pieces. I've only built two other boxes so I'm just learning as I go man, so any advice you can give me is greatly appreciated. I am just looking for suggestions on port sizes etc. after I get my bracing in and account for sub displacement I will probably get more into the port design, since I'll have a better idea of the air space I'll be left with. I'm not very good as designing things, only changing them on the fly and making things more difficult lol. I am looking to make it around 36-38 hertz, do you think that's a decent tuning for these subs? I am wanting to try and pull hair tricks, even if they aren't much of one at all... [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Looking for some help with port calculations.
Top
Menu
Home
Refresh