Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Line Out Converter Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="tez4life" data-source="post: 5443503" data-attributes="member: 572030"><p>Not sure what the "remote trigger" is for, never delt with it with any of the LOCs ive used or installed.</p><p></p><p>You may need a line driver, but honestly, I would install the LOC first and adjust my gains on my amp to see if it will be needed.</p><p></p><p>I had to use one in my car because my amps needed quite a bit of signal (6v) coming through the RCAs, otherwise I had to run the gain up too high on the amp. The LOC was only putting out 2v.</p><p></p><p>This may not be the case in your setup.</p></blockquote><p></p>
[QUOTE="tez4life, post: 5443503, member: 572030"] Not sure what the "remote trigger" is for, never delt with it with any of the LOCs ive used or installed. You may need a line driver, but honestly, I would install the LOC first and adjust my gains on my amp to see if it will be needed. I had to use one in my car because my amps needed quite a bit of signal (6v) coming through the RCAs, otherwise I had to run the gain up too high on the amp. The LOC was only putting out 2v. This may not be the case in your setup. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Line Out Converter Question
Top
Menu
What's new
Forum list
