Reply to thread

Message

<blockquote data-quote="Mexar" data-source="post: 6138206" data-attributes="member: 599759">So, I&#039;ve been playing with this a bit more, no closer to knowing wtf is going on, but more information if it might help someone help me lol.The amp doesn&#039;t fire up right as the deck does, like it should, it takes about 2-3 seconds after the song starts to put out some bass.&nbsp; The louder it tries to play, the faster it goes back into protection.While it&#039;s in protection, the little red LED is solid and steady, the green LED is flashing about 10 times a second (Like flickering on and off, almost like it&#039;s constantly trying to come on but can&#039;t).Also, some times it won&#039;t turn on at all, stays in protection, usually after an over-night sit, it&#039;ll come on, play fine at low volumes (longest test is 10 minutes), then when I turn the car off and back on, it won&#039;t turn on again until it&#039;s had a few hours to sit (the overnight part)If it helps, I used to have it set by DMM running a 1ohm load, and it never had problems before.&nbsp; Changed it back to a 4ohm load now to see if that helped, nada.</blockquote>

[QUOTE="Mexar, post: 6138206, member: 599759"] So, I've been playing with this a bit more, no closer to knowing wtf is going on, but more information if it might help someone help me lol. The amp doesn't fire up right as the deck does, like it should, it takes about 2-3 seconds after the song starts to put out some bass. The louder it tries to play, the faster it goes back into protection. While it's in protection, the little red LED is solid and steady, the green LED is flashing about 10 times a second (Like flickering on and off, almost like it's constantly trying to come on but can't). Also, some times it won't turn on at all, stays in protection, usually after an over-night sit, it'll come on, play fine at low volumes (longest test is 10 minutes), then when I turn the car off and back on, it won't turn on again until it's had a few hours to sit (the overnight part) If it helps, I used to have it set by DMM running a 1ohm load, and it never had problems before. Changed it back to a 4ohm load now to see if that helped, nada. [/QUOTE]

Verification