Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
kx1200.1 not working anymore.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Perdonic" data-source="post: 1742879" data-attributes="member: 563114"><p>Well today I went to set the gain I just wired up the install, and one of my kx1200.1's don't work, it powers up and everything but when I start to raise the gain it goes into protection. I was going to set it with a DMM. the question is:</p><p></p><p>I am getting no output from the speaker connections on the amp when I put the DMM on them:</p><p></p><p>Yes the amp is seeing proper voltage</p><p></p><p>Yes the amp has the right size wire</p><p></p><p>Yes the ground is good(same place as the other amp and that one puts out voltage</p><p></p><p>yes the rca's work because they come in from the deck and then that amp is used to send signal to the amp that works.</p><p></p><p>I opened it up and don't see anything wrong with it, what else could cause this, the amp don't put nothing out and goes into protection easy.</p></blockquote><p></p>
[QUOTE="Perdonic, post: 1742879, member: 563114"] Well today I went to set the gain I just wired up the install, and one of my kx1200.1's don't work, it powers up and everything but when I start to raise the gain it goes into protection. I was going to set it with a DMM. the question is: I am getting no output from the speaker connections on the amp when I put the DMM on them: Yes the amp is seeing proper voltage Yes the amp has the right size wire Yes the ground is good(same place as the other amp and that one puts out voltage yes the rca's work because they come in from the deck and then that amp is used to send signal to the amp that works. I opened it up and don't see anything wrong with it, what else could cause this, the amp don't put nothing out and goes into protection easy. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
kx1200.1 not working anymore.
Top
Menu
What's new
Forum list
