Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Head Units
Kenwood radio protect mode
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="MRobertHowell" data-source="post: 7806547" data-attributes="member: 642831"><p>2 days ago I fried my amp and melted some of the wires, so I took out my entire system. I have my subs and my voltmeter in there still. I still have the RCA's and the blue cable that connects my radio to my amp as well. Those are however just laying around in the back of the car.</p><p></p><p>Anyways, Yesterday I was driving around for several hours, and my radio was working fine. Then today, I was driving around a bit and made it for maybe 20 minutes, then my radio started going in and out for a few seconds, and then the screen said it was in protect mode.</p><p></p><p>After a little while I took the front off, pushed the reset button, and it did it again about 5 minutes later.</p><p></p><p>What I'm wondering, is could it have to do with my RCA cables and the other wire not being plugged into an amp? If not, what could other reasons for this problem be? Thanks.</p></blockquote><p></p>
[QUOTE="MRobertHowell, post: 7806547, member: 642831"] 2 days ago I fried my amp and melted some of the wires, so I took out my entire system. I have my subs and my voltmeter in there still. I still have the RCA's and the blue cable that connects my radio to my amp as well. Those are however just laying around in the back of the car. Anyways, Yesterday I was driving around for several hours, and my radio was working fine. Then today, I was driving around a bit and made it for maybe 20 minutes, then my radio started going in and out for a few seconds, and then the screen said it was in protect mode. After a little while I took the front off, pushed the reset button, and it did it again about 5 minutes later. What I'm wondering, is could it have to do with my RCA cables and the other wire not being plugged into an amp? If not, what could other reasons for this problem be? Thanks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Head Units
Kenwood radio protect mode
Top
Menu
Home
Refresh