Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Kenwood kiv bt900 help please
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="thaglyde" data-source="post: 7931143" data-attributes="member: 645664"><p>Hey fellas. Im new to kenwood and I took time to read the manual (first time in 5 years) but I cant figure out how to get a set of speakers to run off of the amp while another set of speakers are running off of the radio. I did see an internal amp set up and I have not gotten sound by toggling that option. On my Alpine there was a setting but im not sure if it’s the same on the kenwood. Also, Im only running tweets with not crossover to the radio and I wanted to know what a safe crossover setting should be to prevent blowing the tweets on the front channel. If needed, they are a set of hertz bt16 tweets. The specs are:</p><p></p><p>Minimum Frequency Response [Hz]: 3000</p><p></p><p>Maximum Frequency Response [Hz]: 21000</p><p></p><p>Sensitivity (Efficiency) [dB]: 93</p><p></p><p>Peak Power Handling [Watts]: 80</p><p></p><p>RMS Power Handling [Watts]: 80</p><p></p><p>Impedance (per voice coil) [Ohm]: 4</p><p></p><p>Any suggestions would be greatly appreciated.</p></blockquote><p></p>
[QUOTE="thaglyde, post: 7931143, member: 645664"] Hey fellas. Im new to kenwood and I took time to read the manual (first time in 5 years) but I cant figure out how to get a set of speakers to run off of the amp while another set of speakers are running off of the radio. I did see an internal amp set up and I have not gotten sound by toggling that option. On my Alpine there was a setting but im not sure if it’s the same on the kenwood. Also, Im only running tweets with not crossover to the radio and I wanted to know what a safe crossover setting should be to prevent blowing the tweets on the front channel. If needed, they are a set of hertz bt16 tweets. The specs are: Minimum Frequency Response [Hz]: 3000 Maximum Frequency Response [Hz]: 21000 Sensitivity (Efficiency) [dB]: 93 Peak Power Handling [Watts]: 80 RMS Power Handling [Watts]: 80 Impedance (per voice coil) [Ohm]: 4 Any suggestions would be greatly appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Kenwood kiv bt900 help please
Top
Menu
Home
Refresh