Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Just installed line driver
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="xpl0it" data-source="post: 1118520" data-attributes="member: 563062"><p>I just purchased and installed an audiocontrol overdrive. I heard that installing it in the back would work so I did. I just crammed the power wire into my amps 0 gauge power, and the ground to where my amp was grounded, and spliced the remote turn on wire. Anyways, it boots up and shows there is power with the red light, but the 2, 5, 7.5, and maximized lights that show the voltage output do NOT turn on like they are supposed to. I'm pretty sure I did my wiring right because it turns on. Also, when my audio is playing, I still can hear the subwoofer playing and the gain on the audiocontrol and the amplifier have an effect on it. Please help me if I did something wrong.</p></blockquote><p></p>
[QUOTE="xpl0it, post: 1118520, member: 563062"] I just purchased and installed an audiocontrol overdrive. I heard that installing it in the back would work so I did. I just crammed the power wire into my amps 0 gauge power, and the ground to where my amp was grounded, and spliced the remote turn on wire. Anyways, it boots up and shows there is power with the red light, but the 2, 5, 7.5, and maximized lights that show the voltage output do NOT turn on like they are supposed to. I'm pretty sure I did my wiring right because it turns on. Also, when my audio is playing, I still can hear the subwoofer playing and the gain on the audiocontrol and the amplifier have an effect on it. Please help me if I did something wrong. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Just installed line driver
Top
Menu
Home
Refresh