Reply to thread

Message

<blockquote data-quote="Focused84" data-source="post: 307576" data-attributes="member: 549952">I&#039;m wondering if the JL E2150 can push 2- 12w3v2 D2&#039;s ?Or would I need to find something higher on the food chain to push those?AMP&nbsp; SPECS:Specifications:Rated Power (stereo):45W RMS x 2 @ 4 ohm (12.5V);75W RMS x 2 @ 2 ohm (12.5V)Rated Power (bridged):90W RMS x 1 @ 8 ohm (12.5V);150W RMS x 1 @ 4 ohm (12.5V)THD at Rated Power:S/N Ratio:&amp;gt;104 dB referred to rated power (A-weighted, 20 Hz – 20 kHz noise bandwidth)Frequency Response:10 Hz – 25 kHz (+0, -1dB)Damping Factor:&amp;gt;200 @ 4 ohm per ch. / 50 Hz,&amp;gt;100 @ 2 ohm per ch. / 50 HzSlew Rate:± 22V/µsInput Range:200mV – 8V RMSDimensions:9.8&quot; x 9.25&quot; x 2.36&quot;Features:Absolute Symmetry™ Class AB Circuit (U.S. Patent #6,294,959)Differential, Noise-Cancelling Input Topology:RCA jack inputs (low-level) and multi-pin jack (high-level)On-board Crossover:State-variable, 12dB/octave Butterworth with continuously variable cutoff frequency selection from 50 – 200 Hz. Configurable as Low-Pass or High-PassPreamp Output:Pass-through type.Speaker output connections:accept up to 8 AWG wire+12V and Ground connections:accept up to 4 AWG wire</blockquote>

[QUOTE="Focused84, post: 307576, member: 549952"] I'm wondering if the JL E2150 can push 2- 12w3v2 D2's ? Or would I need to find something higher on the food chain to push those? AMP SPECS: Specifications: Rated Power (stereo): 45W RMS x 2 @ 4 ohm (12.5V); 75W RMS x 2 @ 2 ohm (12.5V) Rated Power (bridged): 90W RMS x 1 @ 8 ohm (12.5V); 150W RMS x 1 @ 4 ohm (12.5V) THD at Rated Power: S/N Ratio: >104 dB referred to rated power (A-weighted, 20 Hz – 20 kHz noise bandwidth) Frequency Response: 10 Hz – 25 kHz (+0, -1dB) Damping Factor: >200 @ 4 ohm per ch. / 50 Hz, >100 @ 2 ohm per ch. / 50 Hz Slew Rate: ± 22V/µs Input Range: 200mV – 8V RMS Dimensions: 9.8" x 9.25" x 2.36" Features: Absolute Symmetry™ Class AB Circuit (U.S. Patent #6,294,959) Differential, Noise-Cancelling Input Topology: RCA jack inputs (low-level) and multi-pin jack (high-level) On-board Crossover: State-variable, 12dB/octave Butterworth with continuously variable cutoff frequency selection from 50 – 200 Hz. Configurable as Low-Pass or High-Pass Preamp Output: Pass-through type. Speaker output connections: accept up to 8 AWG wire +12V and Ground connections: accept up to 4 AWG wire [/QUOTE]

Verification