Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
jetta A4 amp rack
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ChefJoe" data-source="post: 167743" data-attributes="member: 546209"><p>you can use a marker on the cardboard, but my recommendation is to cut up some boxes to make a sheet of cardboard you can use, start by trimming to get a rough shape, then keep trimming until you get a tight fit. then you have a template for the spot in the trunk you want to adapt to. Cut board to match. It's not easy to get the angles of curves though, so carpeting over your finished product will help a lot (just fold it back with a little bit loose, push more in as needed to make it smooth).</p></blockquote><p></p>
[QUOTE="ChefJoe, post: 167743, member: 546209"] you can use a marker on the cardboard, but my recommendation is to cut up some boxes to make a sheet of cardboard you can use, start by trimming to get a rough shape, then keep trimming until you get a tight fit. then you have a template for the spot in the trunk you want to adapt to. Cut board to match. It's not easy to get the angles of curves though, so carpeting over your finished product will help a lot (just fold it back with a little bit loose, push more in as needed to make it smooth). [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
jetta A4 amp rack
Top
Menu
Home
Refresh