Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
JBL MS-8 Stock Amplier Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="jdfrank81" data-source="post: 7768104" data-attributes="member: 642240"><p>I currently have a 2010 Evo X MR with the stock Rockford Fosgate Navigation unit and SSS package. This package has an external amp mounted under my drivers seat.</p><p></p><p>I am going to be upgrading all the components in the car and will keep the stock nav unit.</p><p></p><p>Below is a list of the items that I already have purchased:</p><p></p><p>Rockford Fosgate T0D410 10" Dual 4-Ohm Subwoofer</p><p></p><p>Kicker iX1000.5 Amplifier</p><p></p><p>JBL MS-8 In-Line Digital Signal Processor</p><p></p><p>Boston Acoustics SR60 6.5" Components Front and Rear</p><p></p><p>My question pertains to how to hookup the sound processor. I know some of the JL clean sweep products you remove the factory amp, but based on what I read on the JBL manual you wire the output of the factory amp to the processor. Is the signal from head unit strong enough for the input without the stock amplifier? If I keep the stock amplifier will I still retain speaker level control through the head unit?</p></blockquote><p></p>
[QUOTE="jdfrank81, post: 7768104, member: 642240"] I currently have a 2010 Evo X MR with the stock Rockford Fosgate Navigation unit and SSS package. This package has an external amp mounted under my drivers seat. I am going to be upgrading all the components in the car and will keep the stock nav unit. Below is a list of the items that I already have purchased: Rockford Fosgate T0D410 10" Dual 4-Ohm Subwoofer Kicker iX1000.5 Amplifier JBL MS-8 In-Line Digital Signal Processor Boston Acoustics SR60 6.5" Components Front and Rear My question pertains to how to hookup the sound processor. I know some of the JL clean sweep products you remove the factory amp, but based on what I read on the JBL manual you wire the output of the factory amp to the processor. Is the signal from head unit strong enough for the input without the stock amplifier? If I keep the stock amplifier will I still retain speaker level control through the head unit? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
JBL MS-8 Stock Amplier Install
Top
Menu
Home
Refresh