Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Is this the best way to wire this system?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jepalan" data-source="post: 8142148" data-attributes="member: 655519"><p>Nope. You are giving the OP bad advice that may blow his amp. The RF P400-4 is NOT rated for 2-ohms BRIDGED. Check the manual please. When bridged "minimum load impedance is 4 OHMS". Check the spec and manual here:<a href="http://www.crutchfield.com/S-630Ja5R7orN/p_575P4004P/Rockford-Fosgate-Punch-P400-4.html#details-tab" target="_blank">Rockford Fosgate Punch P400-4 4-channel car amplifier 50 watts RMS x 4 at Crutchfield.com</a></p><p></p><p>If he wants to bridge the amp he should wire the speakers in SERIES to 8 OHMS load.</p><p></p><p>Note: he has TWO 4-ohm subs. There is no way to wire two 4-ohm subs and get a single 4-ohm load.</p></blockquote><p></p>
[QUOTE="Jepalan, post: 8142148, member: 655519"] Nope. You are giving the OP bad advice that may blow his amp. The RF P400-4 is NOT rated for 2-ohms BRIDGED. Check the manual please. When bridged "minimum load impedance is 4 OHMS". Check the spec and manual here:[URL="http://www.crutchfield.com/S-630Ja5R7orN/p_575P4004P/Rockford-Fosgate-Punch-P400-4.html#details-tab"]Rockford Fosgate Punch P400-4 4-channel car amplifier 50 watts RMS x 4 at Crutchfield.com[/URL] If he wants to bridge the amp he should wire the speakers in SERIES to 8 OHMS load. Note: he has TWO 4-ohm subs. There is no way to wire two 4-ohm subs and get a single 4-ohm load. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Is this the best way to wire this system?
Top
Menu
Home
Refresh