Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
internally bridged mono question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Prowler573" data-source="post: 1817279" data-attributes="member: 561023"><p>If you are meaning resistance load when you simply say "load" then that's not quite right.</p><p></p><p>The impedence load presented to the amplifier in question is entirely dependant upon the VC configuration of the driver(s) attached to it and the manner in which it (they) are wired. The amp then either does or does not run stable at whatever resistance load it is shown. An amp does not "give" a load to anything.</p></blockquote><p></p>
[QUOTE="Prowler573, post: 1817279, member: 561023"] If you are meaning resistance load when you simply say "load" then that's not quite right. The impedence load presented to the amplifier in question is entirely dependant upon the VC configuration of the driver(s) attached to it and the manner in which it (they) are wired. The amp then either does or does not run stable at whatever resistance load it is shown. An amp does not "give" a load to anything. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
internally bridged mono question
Top
Menu
What's new
Forum list
