Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Installing two amps without a distibution block?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Mills561" data-source="post: 7901671" data-attributes="member: 621946"><p>I already have this distribution block: <a href="http://www.knukonceptz.com/productDetail.cfm?prodID=KNF-23" target="_blank">Fuse Block, Fuse Blocks</a></p><p></p><p>But I was confused about how to properly use it. I have some 4 gauge KnuKonceptz wire that fit perfectly into the 4 gauge terminal... but the other 1/0 I have was a little too small for the bigger terminals. So I basically said **** it, and want to run separate wires.</p><p></p><p>Would I be able to use that distro block for the ground wires?</p></blockquote><p></p>
[QUOTE="Mills561, post: 7901671, member: 621946"] I already have this distribution block: [URL="http://www.knukonceptz.com/productDetail.cfm?prodID=KNF-23"]Fuse Block, Fuse Blocks[/URL] But I was confused about how to properly use it. I have some 4 gauge KnuKonceptz wire that fit perfectly into the 4 gauge terminal... but the other 1/0 I have was a little too small for the bigger terminals. So I basically said **** it, and want to run separate wires. Would I be able to use that distro block for the ground wires? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Installing two amps without a distibution block?
Top
Menu
What's new
Forum list
