Reply to thread

Message

<blockquote data-quote="barrolde" data-source="post: 7229095" data-attributes="member: 630711">Hi Folks,First of all i am more disapointed to be writing this than you are to be reading it //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif I&#039;ve been reading and reading forums but am still a little unsure as to how to properly setup my old crummy hardware.My hardware is:Deck - Panasonic CQ-C1305U (rear RCA pre outs only)Amp - Alpine V12 expert MRV-F405 (4 channel)Door speakers - Alpine SPS-170A 200W max, 40W rmstweeters - unknown sony (hidden under dash atm)sub - not purchased yet but will probably be 1 or 2 modest 8&quot; subs under my seat2 x JL audio passive crossover boxes -&nbsp; have tweeter, woofer and input connectionsMy goals are very modest, just to have this crap hooked up right. Mainly my confusion is around the amp.. never used a 4 chan before.So my deck only has rear pre-outs, i will use Y splitter to run these to chan&#039;s 1,2,3,4 inputs on my amp right?From my amp, I will go out of channel 1 + and - to both crossover boxes and from them to the appropriate speakers right?From my amp, I will go out of channel 2 + and - straight to my sub?Will this work? Any better ways to do it? Any concise and logical advice would be appreciated //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gifCheers!Barry</blockquote>

[QUOTE="barrolde, post: 7229095, member: 630711"] Hi Folks, First of all i am more disapointed to be writing this than you are to be reading it [IMG]//content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif[/IMG] I've been reading and reading forums but am still a little unsure as to how to properly setup my old crummy hardware. My hardware is: Deck - Panasonic CQ-C1305U (rear RCA pre outs only) Amp - Alpine V12 expert MRV-F405 (4 channel) Door speakers - Alpine SPS-170A 200W max, 40W rms tweeters - unknown sony (hidden under dash atm) sub - not purchased yet but will probably be 1 or 2 modest 8" subs under my seat 2 x JL audio passive crossover boxes - have tweeter, woofer and input connections My goals are very modest, just to have this crap hooked up right. Mainly my confusion is around the amp.. never used a 4 chan before. So my deck only has rear pre-outs, i will use Y splitter to run these to chan's 1,2,3,4 inputs on my amp right? From my amp, I will go out of channel 1 + and - to both crossover boxes and from them to the appropriate speakers right? From my amp, I will go out of channel 2 + and - straight to my sub? Will this work? Any better ways to do it? Any concise and logical advice would be appreciated [IMG]//content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif[/IMG] Cheers! Barry [/QUOTE]

Verification