Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Install help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="jarreau2001" data-source="post: 8661832" data-attributes="member: 676003"><p>Thanks DrBoom. So what I found is that bridged mode does actually work. The output is just so low, I have to really crank the system up to hear it through the box and there's hardly any bass.</p><p></p><p>I also found that both speakers are actually in use when I have the box wired to the right or left channel (the box is wired in series). Again, I had to crank it up some to see both speakers flexing. I have it like this now. I tuned it with a 40hz bass tone and it sounds great.</p><p></p><p>Temp on the amp stayed low after an hour of straight thumping. I think it's good to go. I do still need to confirm the ohm difference bridged and unbridged. Im going to reach out to AutoTek.</p><p></p><p>Thanks again!</p></blockquote><p></p>
[QUOTE="jarreau2001, post: 8661832, member: 676003"] Thanks DrBoom. So what I found is that bridged mode does actually work. The output is just so low, I have to really crank the system up to hear it through the box and there's hardly any bass. I also found that both speakers are actually in use when I have the box wired to the right or left channel (the box is wired in series). Again, I had to crank it up some to see both speakers flexing. I have it like this now. I tuned it with a 40hz bass tone and it sounds great. Temp on the amp stayed low after an hour of straight thumping. I think it's good to go. I do still need to confirm the ohm difference bridged and unbridged. Im going to reach out to AutoTek. Thanks again! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Install help
Top
Menu
Home
Refresh