Reply to thread

Message

<blockquote data-quote="NoChance" data-source="post: 1395601" data-attributes="member: 563732">I&#039;m going to be running 2 amps. Nine.1 &amp;amp; Zapco iForce 250.I&#039;ve got a 4 gauge kit that&#039;s going to replace my current setup, I&#039;ve also got better RCAs. These are both connecting to the Nine.1.Now for the Zapco. This is where I need help...I get a distribution block (fused or regular?), and T-connect the Zapco with 8 gauge. Now can I pick up a smaller set of RCAs and connect them from the Nine.1 to the Zapco, instead of running a whole new set? The amps will be like 2 feet apart tops.Now if I can do that, does it mean I only have to run the remote wire from the Nine.1 to the HU?Lastly, the components. I know the wire goes from the amp to the crossovers. But that&#039;s all. Do I use the factory wire inside the door for the 6.5&quot; and the other connectors from the crossover for the tweeter?Any help would be great!</blockquote>

[QUOTE="NoChance, post: 1395601, member: 563732"] I'm going to be running 2 amps. Nine.1 & Zapco iForce 250. I've got a 4 gauge kit that's going to replace my current setup, I've also got better RCAs. These are both connecting to the Nine.1. Now for the Zapco. This is where I need help... I get a distribution block (fused or regular?), and T-connect the Zapco with 8 gauge. Now can I pick up a smaller set of RCAs and connect them from the Nine.1 to the Zapco, instead of running a whole new set? The amps will be like 2 feet apart tops. Now if I can do that, does it mean I only have to run the remote wire from the Nine.1 to the HU? Lastly, the components. I know the wire goes from the amp to the crossovers. But that's all. Do I use the factory wire inside the door for the 6.5" and the other connectors from the crossover for the tweeter? Any help would be great! [/QUOTE]

Verification