Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
Inphase power drive 5000 (on protection)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="R1c4ard" data-source="post: 8683303" data-attributes="member: 677925"><p>Thanks, thinking about it yes I think the green is good to go otherwise you wouldn't know even if the amp was on visually. Shame there is a lack of online material for the model - might be an email direct to InPhase. </p><p></p><p>Just swapped the HU out for a raspberry pi running Moode, wife only let me play for a couple of hours. The other amp running mids and tweeters is working ok but have no bass. Just wanted to check wasn't the amp in first instance.</p><p></p><p>Will run the setup again on the DSP as the input channels are different (guessing this might be the cause now) </p><p></p><p>If not to test the amp could I plug my Moode "low level" output out of the DSP input direct into the amp. Disconnect the sub and check for voltage on the speaker output of the amp? If that makes any sense.</p></blockquote><p></p>
[QUOTE="R1c4ard, post: 8683303, member: 677925"] Thanks, thinking about it yes I think the green is good to go otherwise you wouldn't know even if the amp was on visually. Shame there is a lack of online material for the model - might be an email direct to InPhase. Just swapped the HU out for a raspberry pi running Moode, wife only let me play for a couple of hours. The other amp running mids and tweeters is working ok but have no bass. Just wanted to check wasn't the amp in first instance. Will run the setup again on the DSP as the input channels are different (guessing this might be the cause now) If not to test the amp could I plug my Moode "low level" output out of the DSP input direct into the amp. Disconnect the sub and check for voltage on the speaker output of the amp? If that makes any sense. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
Inphase power drive 5000 (on protection)
Top
Menu
Home
Refresh