Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
id overstock subs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="QtrHorse" data-source="post: 1699693" data-attributes="member: 567206"><p>Ok, I think I have it now. Here are the specs of the amp I will probably be running it w/:</p><p></p><p>2 x 150RMS @ 4 ohms</p><p></p><p>2 x 300RMS @ 2 ohms</p><p></p><p>1 x 600RMS @ 4 ohms mono</p><p></p><p>I will most likely be powering only one 10in sub, so I take it that If I want to do 2x300, I need the dual 2 ohm and If I want to do the 1x600, I need the 4 ohm. The 4ohm setting will run cooler, correct? The amp will most likely be a PPI PC2600 (I hear these amps are known, to run a little warm, is that correct?).</p><p></p><p>If I just use the 5th channel from my PPI 5440, should I stick w/ the 4 ohm?</p><p></p><p>I'm going to go check out that sticky as well, thanks.</p></blockquote><p></p>
[QUOTE="QtrHorse, post: 1699693, member: 567206"] Ok, I think I have it now. Here are the specs of the amp I will probably be running it w/: 2 x 150RMS @ 4 ohms 2 x 300RMS @ 2 ohms 1 x 600RMS @ 4 ohms mono I will most likely be powering only one 10in sub, so I take it that If I want to do 2x300, I need the dual 2 ohm and If I want to do the 1x600, I need the 4 ohm. The 4ohm setting will run cooler, correct? The amp will most likely be a PPI PC2600 (I hear these amps are known, to run a little warm, is that correct?). If I just use the 5th channel from my PPI 5440, should I stick w/ the 4 ohm? I'm going to go check out that sticky as well, thanks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
id overstock subs
Top
Menu
What's new
Forum list
