Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Icon 12" Ported Box
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="agcelica" data-source="post: 8412206" data-attributes="member: 664119"><p>Well I have been messing around with the aeroports, 1 4" isnt enough port area and the 6" might be to big as far as area and length in the box, so I went with 2 4" to try and move them around but they are proving to be quite long for such a small box. The line in the bottom is how long 1 of them will be for 30 hz in 2 ft^3. They both will not fit on the same side because of 7" diameter flares so they might end up being offset on each side, 1 above the other. Only had a little time after work today, I will keep working on it tomorrow. Any suggestions so far?</p><p></p><p>[ATTACH]26552945[/ATTACH]</p></blockquote><p></p>
[QUOTE="agcelica, post: 8412206, member: 664119"] Well I have been messing around with the aeroports, 1 4" isnt enough port area and the 6" might be to big as far as area and length in the box, so I went with 2 4" to try and move them around but they are proving to be quite long for such a small box. The line in the bottom is how long 1 of them will be for 30 hz in 2 ft^3. They both will not fit on the same side because of 7" diameter flares so they might end up being offset on each side, 1 above the other. Only had a little time after work today, I will keep working on it tomorrow. Any suggestions so far? [ATTACH=CONFIG]26552945[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Icon 12" Ported Box
Top
Menu
Home
Refresh