Reply to thread

Message

<blockquote data-quote="lubetek" data-source="post: 8550751" data-attributes="member: 565332">Yes it is a small amp. I have other larger amps. I have amps that I&#039;m not using. Here is the deal; This is for my weekend ride, a 1965 Ford F100 with literally 1/2&quot; under the bench seat, a gas tank behind the seat and a factory air conditioner that takes up half the room between the center of the seat and dash leaving me with 9 inches of free space on the floor which is where my compact sub sits. I have no room for almost any normal sized amp or sub. So I needed an amp that would fit under the dash. Hence &#039;micro&#039; amp.That said this micro amp puts out a good amount of power. I can&#039;t see that as being an issue. Here is this amp on the dyno:[MEDIA=youtube]99tiyWuuAGM[/MEDIA] (this is what sold me on it)I thought I was gain matching the amp to hu since the hu puts out 4 volts from the preouts and I set the amps input sensitivity to 4 volts.My question really is would setting the amp to a lower input sensitivity voltage provide more output at a lower volume from the hu without hurting the amp?</blockquote>

[QUOTE="lubetek, post: 8550751, member: 565332"] Yes it is a small amp. I have other larger amps. I have amps that I'm not using. Here is the deal; This is for my weekend ride, a 1965 Ford F100 with literally 1/2" under the bench seat, a gas tank behind the seat and a factory air conditioner that takes up half the room between the center of the seat and dash leaving me with 9 inches of free space on the floor which is where my compact sub sits. I have no room for almost any normal sized amp or sub. So I needed an amp that would fit under the dash. Hence 'micro' amp. That said this micro amp puts out a good amount of power. I can't see that as being an issue. Here is this amp on the dyno: [MEDIA=youtube]99tiyWuuAGM[/MEDIA] (this is what sold me on it) I thought I was gain matching the amp to hu since the hu puts out 4 volts from the preouts and I set the amps input sensitivity to 4 volts. My question really is would setting the amp to a lower input sensitivity voltage provide more output at a lower volume from the hu without hurting the amp? [/QUOTE]

Verification