Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
I need help with a box design
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ridered36" data-source="post: 109849" data-attributes="member: 546154"><p>OK. sounds great.</p><p></p><p>So the divider just goes straight down the middle then to seperate the chambers?</p><p></p><p>Also, if i decide to change the width to make it a little smaller can i just add it to the depth or is this gonna throw the tuning off?</p><p></p><p>Does a flared port mean it has a lip on the outside so it will install flush against the box? Do i just use PVC for the port and run it straight back 22"?</p><p></p><p>Sorry for all the questions, but i am only 15 and on a limited budget so i want to get everything right the first time. Yuo are really helping me out and i appreciate your time. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif</p></blockquote><p></p>
[QUOTE="ridered36, post: 109849, member: 546154"] OK. sounds great. So the divider just goes straight down the middle then to seperate the chambers? Also, if i decide to change the width to make it a little smaller can i just add it to the depth or is this gonna throw the tuning off? Does a flared port mean it has a lip on the outside so it will install flush against the box? Do i just use PVC for the port and run it straight back 22"? Sorry for all the questions, but i am only 15 and on a limited budget so i want to get everything right the first time. Yuo are really helping me out and i appreciate your time. [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
I need help with a box design
Top
Menu
Home
Refresh