Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
How much Power is to much Power
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="THATpurpleKUSH" data-source="post: 8691795" data-attributes="member: 615398"><p>No because impedance rise raises the actual load anywhere from roughly 1.5-10x nominal</p><p></p><p>Ex 1:</p><p>Sundown E10v3 D4s wired to 1 ohm nominal, RE is .76 for both</p><p></p><p>Actual load the amp sees is anywhere from 1.2 - 5 ohms</p><p></p><p></p><p>[ATTACH=full]19938[/ATTACH]</p><p></p><p></p><p></p><p>As nominal resistance of the driver goes up impedance peaks get higher. That's why you want to wire as low as possible to get the most power out of the amp.</p><p></p><p>Ex 2:</p><p>JL Audio 15W0 8 ohm SVC with RE of 7.56</p><p></p><p>11.01 -- 101.3 ohms</p><p></p><p>[ATTACH=full]19939[/ATTACH]</p><p></p><p></p><p>The maximas (peak) in the curves represent vent and driver resonances and the minima (valley) represents system resonance of the box.</p><p></p><p>One is for SPL application, the other is a home theatre application.</p></blockquote><p></p>
[QUOTE="THATpurpleKUSH, post: 8691795, member: 615398"] No because impedance rise raises the actual load anywhere from roughly 1.5-10x nominal Ex 1: Sundown E10v3 D4s wired to 1 ohm nominal, RE is .76 for both Actual load the amp sees is anywhere from 1.2 - 5 ohms [ATTACH type="full" alt="19938"]19938[/ATTACH] As nominal resistance of the driver goes up impedance peaks get higher. That's why you want to wire as low as possible to get the most power out of the amp. Ex 2: JL Audio 15W0 8 ohm SVC with RE of 7.56 11.01 -- 101.3 ohms [ATTACH type="full" alt="19939"]19939[/ATTACH] The maximas (peak) in the curves represent vent and driver resonances and the minima (valley) represents system resonance of the box. One is for SPL application, the other is a home theatre application. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
How much Power is to much Power
Top
Menu
Home
Refresh