Reply to thread

Message

<blockquote data-quote="Slaugh" data-source="post: 949695" data-attributes="member: 560795">hey i have my system but im finding it tricky to set up... i just never get to a point where it pleases me so i go back to the beggining and try again... it suckshow do you set your sound? so far im leaving amps flat and doing the cutouts from the head unit (Alpine CDA-9815) i got the built-in X-Over set asLow- 80hz -12db/octaveMid-Low - Flat (i still havent found a good cut for this frequency =[)Mid-High - Flat (same as above =[ )High - -2db, 3,2khz, -18db/octaveand the Equalizer is set asBass - Level: +5db, width: 1, frequency: 100hzMid-Bass - Level: +4db, width: 1, frequency: 250hzMid - Level: -1, width: 3, frequency: 1.0khzMid-Treble - Level: +2db, width: 3, frequency: 4.0khzTreble - Level: +3, width: 2, frequency: 12khzMX button is Off (sometimes i use it on 2 thou)well the system is not ok yet... the system quite much lacks bass (even with the MX, which also kills my stereo quality), it&#039;s just not good as i want...what do you recommend me to change?how do i find the correct cutouts for my component speaker Mid-bass???post your configs if you use Alpine with 5band equalization, i might try it too...</blockquote>

[QUOTE="Slaugh, post: 949695, member: 560795"] hey i have my system but im finding it tricky to set up... i just never get to a point where it pleases me so i go back to the beggining and try again... it sucks how do you set your sound? so far im leaving amps flat and doing the cutouts from the head unit (Alpine CDA-9815) i got the built-in X-Over set as Low- 80hz -12db/octave Mid-Low - Flat (i still havent found a good cut for this frequency =[) Mid-High - Flat (same as above =[ ) High - -2db, 3,2khz, -18db/octave and the Equalizer is set as Bass - Level: +5db, width: 1, frequency: 100hz Mid-Bass - Level: +4db, width: 1, frequency: 250hz Mid - Level: -1, width: 3, frequency: 1.0khz Mid-Treble - Level: +2db, width: 3, frequency: 4.0khz Treble - Level: +3, width: 2, frequency: 12khz MX button is Off (sometimes i use it on 2 thou) well the system is not ok yet... the system quite much lacks bass (even with the MX, which also kills my stereo quality), it's just not good as i want... what do you recommend me to change? how do i find the correct cutouts for my component speaker Mid-bass??? post your configs if you use Alpine with 5band equalization, i might try it too... [/QUOTE]

Verification