Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
how do i setup 3 way active setup using the HU?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ngsm13" data-source="post: 1621710" data-attributes="member: 544830"><p>If you want to go active, you will have to ditch the component set in the rear. Unhook it from the amp.</p><p></p><p>Now, you will need to pull out your HU... and flip a little switch on the bottom to "3-way" mode. Then, you will need to run your "front" RCA's to the front 2 channels of your 300/4, this will power your front set of tweeters only. Next, run your "rear" RCA's to Channels 3/4 on the 300/4, this will power the front set of mid ONLY. You will need to select proper XOVER slopes and frequencies from your HU. This will feed the proper signal to the amp, and the amp will then power your speakers within the corret bandwidths.</p><p></p><p>That's like a quick *** overview of what to do...</p><p></p><p>nG</p></blockquote><p></p>
[QUOTE="ngsm13, post: 1621710, member: 544830"] If you want to go active, you will have to ditch the component set in the rear. Unhook it from the amp. Now, you will need to pull out your HU... and flip a little switch on the bottom to "3-way" mode. Then, you will need to run your "front" RCA's to the front 2 channels of your 300/4, this will power your front set of tweeters only. Next, run your "rear" RCA's to Channels 3/4 on the 300/4, this will power the front set of mid ONLY. You will need to select proper XOVER slopes and frequencies from your HU. This will feed the proper signal to the amp, and the amp will then power your speakers within the corret bandwidths. That's like a quick *** overview of what to do... nG [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
how do i setup 3 way active setup using the HU?
Top
Menu
What's new
Forum list
