Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
High level input vs low level input
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Lasherž" data-source="post: 8708976" data-attributes="member: 679555"><p>So long as your LC2i is set up to be near maximized at your system's highest clean volume level then all that matters is that your amp isn't clipping. The bigger the signal the better (so long as it's not clipping), because it will help remove any potential interference. The only time you'll want to turn down the LC2i when it's not maximizing at high volumes is if your amp's lowest gain setting is still too loud. In terms of the "correct setting" for the amp though it's low input. High input is for running direct from speaker wires, not an LOC.</p><p></p><p>Pretty sure n2audio is right about you having low and high switched.</p></blockquote><p></p>
[QUOTE="Lasherž, post: 8708976, member: 679555"] So long as your LC2i is set up to be near maximized at your system's highest clean volume level then all that matters is that your amp isn't clipping. The bigger the signal the better (so long as it's not clipping), because it will help remove any potential interference. The only time you'll want to turn down the LC2i when it's not maximizing at high volumes is if your amp's lowest gain setting is still too loud. In terms of the "correct setting" for the amp though it's low input. High input is for running direct from speaker wires, not an LOC. Pretty sure n2audio is right about you having low and high switched. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
High level input vs low level input
Top
Menu
Home
Refresh