Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Speakers
Hertz HSK165 - Install question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Topless Stang" data-source="post: 6627958" data-attributes="member: 611689"><p>I was afraid of that....the super glue held? I might pick up some epoxy then...I'm thinking the super glue might not hold due to the force I have to exert to push them into the metal rings. Did you use the trim ring? I just bought a 2" hole saw &amp; mandrel bit after looking at someone else's DIY, and the metal rings are 'slightly' and I mean slight;y larger than 2". I'll see whats up later this week I suppose. Does anyone have any pics of them flush mounted, or the install process?</p><p></p><p>Racerx250,</p><p></p><p>What did you use to cut out the mounting hole? I bought a 2" hole saw, but its too big. I measured them tonight and I'm thinking of picking up up a 1-5/8" hole saw tomorrow.</p></blockquote><p></p>
[QUOTE="Topless Stang, post: 6627958, member: 611689"] I was afraid of that....the super glue held? I might pick up some epoxy then...I'm thinking the super glue might not hold due to the force I have to exert to push them into the metal rings. Did you use the trim ring? I just bought a 2" hole saw & mandrel bit after looking at someone else's DIY, and the metal rings are 'slightly' and I mean slight;y larger than 2". I'll see whats up later this week I suppose. Does anyone have any pics of them flush mounted, or the install process? Racerx250, What did you use to cut out the mounting hole? I bought a 2" hole saw, but its too big. I measured them tonight and I'm thinking of picking up up a 1-5/8" hole saw tomorrow. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Speakers
Hertz HSK165 - Install question
Top
Menu
Home
Refresh