Reply to thread

Message: <blockquote data-quote="SethPhillips" data-source="post: 4602669" data-attributes="member: 559176">you will need a 4ga wire kit, with a disto block. and 8ga from the disto to the amps.in the ex cab ford's, there is not a whole lot of room depending on where you are putting the sub(s) usually i put the amps under driver and pass seats.on the 4 ch you will need 4ch rca's. and 9 wire. Stinger makes the 9 wire, it consist's of all youre speaker wires and a rem wire all in a caseing. run the nine wire from youre 4ch amp's output's up behind the deck into a aftermarket wire harness of to the factory harness to the speakers.then 2 ch rca's off to the 500/1.hope that helps.</blockquote>

Top