Reply to thread

Message

<blockquote data-quote="s_krillin" data-source="post: 2485963" data-attributes="member: 572774">Hi there, I am new to this forum and signed up because of all the knowledge that is out there. I would like to run some numbers by to see what you think. This is what I have and plan to run.2 Lanzar Opti 2x300150 Watts x 2 RMS Power into 4 Ohms300 Watts x 2 Max Power into 4 Ohms600 Watts x 1 Max Power at 4 Ohms Bridged250 x 2 Watts RMS Power into 2 OhmsMinimum Speaker Impedance: 2 Ohms1 Alpine SWR-1242DRMS Power Range : 50-500 WattsPeak Power Handling: 1500 WattsImpedance: Dual 4 OhmI plan to place the single sub in a Bandpass box with the Dim. about&nbsp; 15x15x20 giving me about 1.74023 cu. ftWiring each voice coil to one amp.&nbsp; What do you guys think. Are the amps ok for this aplication and what should my port size B?Thanks in advance</blockquote>

[QUOTE="s_krillin, post: 2485963, member: 572774"] Hi there, I am new to this forum and signed up because of all the knowledge that is out there. I would like to run some numbers by to see what you think. This is what I have and plan to run. 2 Lanzar Opti 2x300 150 Watts x 2 RMS Power into 4 Ohms 300 Watts x 2 Max Power into 4 Ohms 600 Watts x 1 Max Power at 4 Ohms Bridged 250 x 2 Watts RMS Power into 2 Ohms Minimum Speaker Impedance: 2 Ohms 1 Alpine SWR-1242D RMS Power Range : 50-500 Watts Peak Power Handling: 1500 Watts Impedance: Dual 4 Ohm I plan to place the single sub in a Bandpass box with the Dim. about 15x15x20 giving me about 1.74023 cu. ft Wiring each voice coil to one amp. What do you guys think. Are the amps ok for this aplication and what should my port size B? Thanks in advance [/QUOTE]

Verification