Reply to thread

Message

<blockquote data-quote="Elvenking" data-source="post: 8274398" data-attributes="member: 661211">Just got all installed tonight after about 4 hours of car contorting. Added the new JX360/4 4ch bridged stereo to the mid drivers and the JX360/2 on the tweets....the Kicker remains kicking the 12&quot; DVC Polk which it seems to do quite well for my taste...for now //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif. Just removed the seats and went to work. About all I have had time for is a electrical check, power on, left/right check and the fact that each output was going to the right network and xover settings. All checked out. Tomorrow will be some quality time tweaking for sound. No engine whine in the ground...so good for that. I had to come in and pay attention to my lil buddy...an African Grey Parrot named Isaac. I&#039;ll tune tomorrow and let ya know how it goes.About the mid\tweets xover point. The factory passives had them crossing over at around 3.8KHz @ 6db/octave. I definitely want to avoid sending too much lower than that to the tweet correct? I was thinking that a similar xover point would be somewhere around the 4KHz setting on the 80PRS or higher....and I am curious to try optimizing these settings. How do folks usually end up massaging this xover point? Thanks for all your help!CheersStephen</blockquote>

[QUOTE="Elvenking, post: 8274398, member: 661211"] Just got all installed tonight after about 4 hours of car contorting. Added the new JX360/4 4ch bridged stereo to the mid drivers and the JX360/2 on the tweets....the Kicker remains kicking the 12" DVC Polk which it seems to do quite well for my taste...for now [IMG]//content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif[/IMG]. Just removed the seats and went to work. About all I have had time for is a electrical check, power on, left/right check and the fact that each output was going to the right network and xover settings. All checked out. Tomorrow will be some quality time tweaking for sound. No engine whine in the ground...so good for that. I had to come in and pay attention to my lil buddy...an African Grey Parrot named Isaac. I'll tune tomorrow and let ya know how it goes. About the mid\tweets xover point. The factory passives had them crossing over at around 3.8KHz @ 6db/octave. I definitely want to avoid sending too much lower than that to the tweet correct? I was thinking that a similar xover point would be somewhere around the 4KHz setting on the 80PRS or higher....and I am curious to try optimizing these settings. How do folks usually end up massaging this xover point? Thanks for all your help! Cheers Stephen [/QUOTE]

Verification