Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Help with box design for 2 10" Alpine R series
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="colinmustlift" data-source="post: 8645664" data-attributes="member: 674867"><p>shred hooked me up w some plans. I've made one change, i'm extending the top 1 inch wider and doing a dado cut, just to give myself a lip on each side to pick it up by.</p><p></p><p>did most of the initial cuts, will try to find time on the weekend to do the rest. got some bed liner to paint it. I also got a new amp (alpine pdx m12, like 1400 watts into either 2 or 4 ohms) which will power the subs nice and sips power gently so i won't mess up stock electrical.</p><p></p><p>so a question for my next bad idea: i'm assuming down the road i will want to experiment, and the sub channel on my 5 channel amp will be sitting unused -- are there any subs that would work well in 3 without going over say 3 cubes for a good ported box? i'd power 2 off of my new amp, and 1 off of the other amp (alpine v9), which i can set to be exactly the same power and control all of them w one gain knob. would adding another R series 10 inch be out of the question?</p></blockquote><p></p>
[QUOTE="colinmustlift, post: 8645664, member: 674867"] shred hooked me up w some plans. I've made one change, i'm extending the top 1 inch wider and doing a dado cut, just to give myself a lip on each side to pick it up by. did most of the initial cuts, will try to find time on the weekend to do the rest. got some bed liner to paint it. I also got a new amp (alpine pdx m12, like 1400 watts into either 2 or 4 ohms) which will power the subs nice and sips power gently so i won't mess up stock electrical. so a question for my next bad idea: i'm assuming down the road i will want to experiment, and the sub channel on my 5 channel amp will be sitting unused -- are there any subs that would work well in 3 without going over say 3 cubes for a good ported box? i'd power 2 off of my new amp, and 1 off of the other amp (alpine v9), which i can set to be exactly the same power and control all of them w one gain knob. would adding another R series 10 inch be out of the question? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Help with box design for 2 10" Alpine R series
Top
Menu
Home
Refresh