Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
HELP! - Wiring 1st System
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="bobberadam" data-source="post: 7680480" data-attributes="member: 640346"><p>My amp is a cheaper low end amp, Lanzar HTG237 1000 Watt 2 Channel Mosfet Amplifier. Volume is more important than Sound Quality.</p><p></p><p>My speakers are 6.5" (Pair) Pyle Audio PLMRW65 200 Watt Two Way Speakers.</p><p></p><p>Is it bettert to configure as 2 x 125W RMS at 4 OHMS or 2 x 225W RMS at 2 OHMS per my amp configuration options. The first option would be a single pair split between channels and the second option would be 4 speakers as parallel connected pairs.</p><p></p><p>Should I be concerned about any risk to my amp or speakers in either configuration?</p></blockquote><p></p>
[QUOTE="bobberadam, post: 7680480, member: 640346"] My amp is a cheaper low end amp, Lanzar HTG237 1000 Watt 2 Channel Mosfet Amplifier. Volume is more important than Sound Quality. My speakers are 6.5" (Pair) Pyle Audio PLMRW65 200 Watt Two Way Speakers. Is it bettert to configure as 2 x 125W RMS at 4 OHMS or 2 x 225W RMS at 2 OHMS per my amp configuration options. The first option would be a single pair split between channels and the second option would be 4 speakers as parallel connected pairs. Should I be concerned about any risk to my amp or speakers in either configuration? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
HELP! - Wiring 1st System
Top
Menu
What's new
Forum list
