Reply to thread

Message

<blockquote data-quote="Immociide" data-source="post: 7100698" data-attributes="member: 598012">The wires are hooked up right, because it works.there&#039;s 5 knobs and 2 switches:Phase Shift: 0/180 (set at 0)Input Gain: 9V-200mV (3/4 turn)&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; With a 5 volt deck you are clipping it, that guy at the shop is an idiot. Bass EQ: 0-12db (set at 11 oclock)&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; Turn this to 0. It is bass boost, useless.Subsonic: 10-50 (11 oclock)&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; Try to visualize the numbers around the dial and set it to 20hz. If you are using a sealed box then it is not needed, usually. Bass Focus: 0-7db (11 oclock)&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;&nbsp; This adds low frequencies to your bass, supposedly for sealed boxes.... Im not sure exactly how it work so its up to you to do as you wish. To me it sounds like another bass boost just for lower freq. I would personally turn it off. Low Pass: 50-250 (3/4 turn)&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; Again visualize the numbers and turn it down to 80-100hz its probably around the 190 mark atmBridged Amplifier Mode: Master, Slave 1, Slave 2 (set to Master)HU, on &quot;sub&quot;, is set to &quot;Sub Level: +4 (max = +8)&quot;&nbsp; If this is like my headunit than it actually does control the &quot;sub level&quot; and is not a bass boost like most. Set this to 0 until you have your amp set properly. </blockquote>

[QUOTE="Immociide, post: 7100698, member: 598012"] The wires are hooked up right, because it works. there's 5 knobs and 2 switches: Phase Shift: 0/180 (set at 0) Input Gain: 9V-200mV (3/4 turn) [B]With a 5 volt deck you are clipping it, that guy at the shop is an idiot. [/B] Bass EQ: 0-12db (set at 11 oclock) [B]Turn this to 0. It is bass boost, useless.[/B] Subsonic: 10-50 (11 oclock) [B]Try to visualize the numbers around the dial and set it to 20hz. If you are using a sealed box then it is not needed, usually. [/B] Bass Focus: 0-7db (11 oclock) [B]This adds low frequencies to your bass, supposedly for sealed boxes.... Im not sure exactly how it work so its up to you to do as you wish. To me it sounds like another bass boost just for lower freq. I would personally turn it off. [/B] Low Pass: 50-250 (3/4 turn) [B]Again visualize the numbers and turn it down to 80-100hz its probably around the 190 mark atm[/B] Bridged Amplifier Mode: Master, Slave 1, Slave 2 (set to Master) HU, on "sub", is set to "Sub Level: +4 (max = +8)" [B]If this is like my headunit than it actually does control the "sub level" and is not a bass boost like most. Set this to 0 until you have your amp set properly. [/B] [/QUOTE]

Verification