Reply to thread

Message

<blockquote data-quote="IonSQL" data-source="post: 2801963" data-attributes="member: 565746">So I finally got around to getting my new equipment installed, but I&#039;m having some confusion with the amp... Memphis Belle 16-MC1300d (the chrome one)Head unit is Sony XAV-A1 screen... wiring is as follows:--Front HU preouts: single set of RCA&#039;s, left channel is split to channel A on the amp, and right channel is split to channel B on the amp-- Rear HU preouts: none-- Sub HU preout: single set of RCA&#039;s, combined at the amp for the mono sub input-- Each channel on the amp is bridged and set for 150w per channel to a set of Crystal SSCS6-- Sub channel is set for 1000w @ 1 ohm to (4) eD 9Kv.3&#039;sEverything gets wired up, and I turn on the car.&nbsp; Wait for the bass to hit, and only hear the comps.&nbsp; Hmm...&nbsp; so I open the trunk, and nothing.&nbsp; Unhook the RCA from the sub channel at the amp, and voila, bass.&nbsp; Hook the RCA back in, and no bass.HPF for the comps are set to ~100Hz at the amp, and LPF for the sub is at about 80Hz at the amp.&nbsp; SSF is turned off, filter selector is set to HPF.I confirmed that the RCA&#039;s are hooked up to the correct inputs at the amp and outputs at the HU...I&#039;m lost... any ideas?</blockquote>

[QUOTE="IonSQL, post: 2801963, member: 565746"] So I finally got around to getting my new equipment installed, but I'm having some confusion with the amp... Memphis Belle 16-MC1300d (the chrome one) Head unit is Sony XAV-A1 screen... wiring is as follows: --Front HU preouts: single set of RCA's, left channel is split to channel A on the amp, and right channel is split to channel B on the amp -- Rear HU preouts: none -- Sub HU preout: single set of RCA's, combined at the amp for the mono sub input -- Each channel on the amp is bridged and set for 150w per channel to a set of Crystal SSCS6 -- Sub channel is set for 1000w @ 1 ohm to (4) eD 9Kv.3's Everything gets wired up, and I turn on the car. Wait for the bass to hit, and only hear the comps. Hmm... so I open the trunk, and nothing. Unhook the RCA from the sub channel at the amp, and voila, bass. Hook the RCA back in, and no bass. HPF for the comps are set to ~100Hz at the amp, and LPF for the sub is at about 80Hz at the amp. SSF is turned off, filter selector is set to HPF. I confirmed that the RCA's are hooked up to the correct inputs at the amp and outputs at the HU... I'm lost... any ideas? [/QUOTE]

Verification