Reply to thread

Message: <blockquote data-quote="Savant" data-source="post: 138259" data-attributes="member: 546108">Where is the amp?? the ground from the amp should be as short as you can make it.. and yeah, if the ground isn't all that good you won't be able to flow the current you need.The RCAs from the HU go to the input (RCA) on the amp.. It's a 4 channel amp so you might have to supply signal to all 4 inputs on the amp if you are gonna bridge it.. you can just get some splitters if you need to.. front to both front, rear to both rear.. if you only have one set of pre-amp outs, you will have to split the RCAs to all 4 channels... To bridge, you run from the + on one channel to the - of the other channel (one + and one - will be unused).. There should be something on the speaker outputs on the amp that show which posts to use to 'bridge'..Hope that helps..</blockquote>

Top