Reply to thread

Message

<blockquote data-quote="Papermaker85" data-source="post: 8460500" data-attributes="member: 572595"><a href="http://s172.photobucket.com/user/papermaker85/media/prototype/5031193B-AA65-42CB-AC61-A735AEC0A81E-4784-00000367EAD10ED5.mp4.html?o=22" target="_blank">5031193B-AA65-42CB-AC61-A735AEC0A81E-4784-00000367EAD10ED5.mp4 Video by papermaker85 | Photobucket</a><a href="http://s172.photobucket.com/user/papermaker85/media/1DF18C75-992F-4753-AC0F-D4BEFF75CE6C-4737-00000363BFA25A78.mp4.html?o=24" target="_blank">1DF18C75-992F-4753-AC0F-D4BEFF75CE6C-4737-00000363BFA25A78.mp4 Video by papermaker85 | Photobucket</a>that was about 1500 RMS. never put it into production because COP side swiped me and they turned the **** around on me. had one drink and blew over the limit.. needless to say i was out of pocket about 15k..this pituclar driver perfered port are to box size as well.. FS was 30 and QE was .55.. loaded the driver with a smaller box and had 65in^2 of port area. 3.25 cube.. xmax was like 28mm IIRC 18mm top plate full pole shorting ring and a alum shorting ring faced off the same ID as ID as the topplate it sat inbetween the magnets ID and faced off to the ID of the TP.. i liked it.. wanted abit more motor strength but it was real natural and smooth..</blockquote>

[QUOTE="Papermaker85, post: 8460500, member: 572595"] [URL="http://s172.photobucket.com/user/papermaker85/media/prototype/5031193B-AA65-42CB-AC61-A735AEC0A81E-4784-00000367EAD10ED5.mp4.html?o=22"]5031193B-AA65-42CB-AC61-A735AEC0A81E-4784-00000367EAD10ED5.mp4 Video by papermaker85 | Photobucket[/URL] [URL="http://s172.photobucket.com/user/papermaker85/media/1DF18C75-992F-4753-AC0F-D4BEFF75CE6C-4737-00000363BFA25A78.mp4.html?o=24"]1DF18C75-992F-4753-AC0F-D4BEFF75CE6C-4737-00000363BFA25A78.mp4 Video by papermaker85 | Photobucket[/URL] that was about 1500 RMS. never put it into production because COP side swiped me and they turned the **** around on me. had one drink and blew over the limit.. needless to say i was out of pocket about 15k.. this pituclar driver perfered port are to box size as well.. FS was 30 and QE was .55.. loaded the driver with a smaller box and had 65in^2 of port area. 3.25 cube.. xmax was like 28mm IIRC 18mm top plate full pole shorting ring and a alum shorting ring faced off the same ID as ID as the topplate it sat inbetween the magnets ID and faced off to the ID of the TP.. i liked it.. wanted abit more motor strength but it was real natural and smooth.. [/QUOTE]

Verification